High Quality Tractec Winch for Offroad Cars

Product Description

Introduction
The TracTec range of competition winches has been designed and built to give the highest level of performance in a demanding world. Using materials and designs that set it apart from all its competitors, is the standard that others aspire too. Our winches have been built to give the end user total reliability in the toughest of situations and supply unequalled power, speed, and reliability at those critical moments This manual will provide you with the information that you require to fit, use and maintain your TT90 winch. Mountings: TT90 winches have 12 mounting bolt positions and can be fitted standing or lying flat. A minimum of six retaining bolts must be used at all times. A winch mount/plate with a minimum thickness of 8mm must be used and be well-secured to the vehicle. Failure to do so could result in damage to the winch or vehicle.
*Warning*
Failure to fit the winch correctly could result in damage to the winch or vehicle. Fitting the winch to a weak or bent winch plate could result in poor operation or damage to the winch or free spool mechanism. Wiring This winch is supplied with two TT Super Duty Albright contactor packs, ready wired to the motors, and a wiring diagram. Please follow the next tips. 1/ Use 60/70mm2 Cable from the batteries to the red booted terminal on the contactors via a suitable cutoff switch 2/ Use 60/70mm2 cable from the battery earth (ground) to the rear motor earth (ground) point located under the motor 3/ Use 40/50mm2 or larger cable from the solenoids to the motors (if installing your own motors & solenoids) 4/ Fit the contactors as close to the winches as possible. 5/ Use quality batteries, we recommend high performance lithium battery 6/ Use quality cable and battery terminals that are professionally fitted. 7/ The use of a 100amp (12v) plus the alternator is recommended. 8/ Always use quality motors from a known source, We recommend the use of matched motors.
*Warning*
Failure to earth (ground) the winch correctly or to use incorrect cables could result in damage to the winch or vehicle's electrical system Winch ropes and cables Our winches are very powerful and require strong ropes to avoid breakages. We recommend the use of 11mm synthetic rope or the equivalent strength. (10.5ton/210001b) We do not recommend the use of steel rope. However, if it must be used we advise that a minimum of 10mm is used with a roller fairlead. *Warning* The use of old, damaged, or unsuitable ropes or cables could cause personal injury or damage to the vehicle/winch. Free spool fitting and operation Follow the simple diagram for fitting the free spool control solenoid and operating switch and pipe work. (Page 13) When mounting the switch, try to mount it in a position where it is easily seen and cannot be knocked accidentally. When using the free spool for the first time, follow these simple rules to ensure positive operation: 1/ Before disengaging the free spool, be sure there is no load on the winch or cable2/ When removing the cable from the drum, take care not to accidentally knot the rope. 3/ After re-engaging the free spool we recommend that you run the winch 'out' approx 1 metre and then 'in' to allow the free spool mechanism to engage fully before applying load.

TT90 Features&Specifications
weight	60Kg	Fairlead	Carved Alloy Steel	Battery Leads	Φ≥50mm²
Synthetic Rope	12mmx40m	Waterful	IP67	Braking	External Ratchet Brake
Full Load Line speed	9.8M/Min6.3M/Min	Finish	Grey	Clutch	Pneumatic
No Load Line speed	39.8M/Min25.5M/Min	Drum Size	63mm	Gear Train	3-Stage Planetary
Rated Line Pull	14000Lbs(6300Kgs)	No Load Current	103A	Fulload curent	568A
Gear Reduction Ratio	57.6:1	Overall Dimensions	524X260X389mm	Ecommended Battery	Not Less than 2 pices of 90Ah BATTERY
Solenoid style	Albright integrated solenoid	Mounting Bolt	M12

*Warning*
Failure to follow the above instructions could result in injury or damage to your winch Using your TT90 winch TracTec winches are very fast and powerful and require respect during use Here are a few tips and techniques that will help you get the most from your winch. 1/ Place your winch switches in a location where they are easy to use and see, and also somewhere they cannot be knocked easily. 2/ NEVER put your limbs close to the fairlead or near the winch during operation. 3/ Always make sure you use a secure winching point/ground anchor. 4/ Do not stall your winch, if your winch should slow down or near stalling STOP. Check for obstructions under or in front of your vehicle or possible faults with your electrical system. 5/ Always allow the winch to stop turning before switching in a different direction.6/ When winching, try to keep your wheels turning at the same speed as the winch. This will help aid traction and help get the most from the winch. 7 Always keep the winch line under tension this will help to eliminate the chance of over-spooling or ropes becoming wrapped around the winch, which could lead to breakages or premature rope failure. It will also reduce the risk of "dynamic" loading and therefore increase reliability. 8/ Do not allow the cable to 'Bunch' on the drum this could lead to the tie bars being bent or in the worst case breaking the winch casing and or damaging the rope.
Maintenance Care of your TracTec winch is paramount to its reliability and continuous high performance. Here are a few tips and recommendations: The TT90 winch holds 0.25 liter of oil and various grades can be used depending on the location and temperature of the climate. We recommend using a 1-shot SAE 30 winch oil(G10014) for most climate conditions, when in extremely cold climates use Dextron 11ATF. The winch oil should be changed on a regular basis at least yearly. It is recommendable to replace the winch oil after 3 days of competition use. After prolonged use, we recommend stripping the motors and cleaning them. Check the brushes and holders for correct operation. Clean the brake assembly using water to remove mud and dust, after cleaning apply a thin film of the water repellent (WD40 or equivalent) The use of oil-based products is okay TracTec winch brakes can be run dry or with grease and oil. Note: Do not leave the brake assembly locked. Always make sure the ratchet can turn freely if the winch is being stored between events. Spare parts: A full range of consumables, services, and spare parts are available for the TT90winch range. Contact us for pri

---

>> New type corn sheller and corn peeling machine on sale
>> Polyester Nylon Hook and Loop Fastener Tape
>> Plastic Injection Turnover Box Moulding, Food Container Mold, Storage Container Mould
>> DNA/RNA Nucleic Acid Extractor Automatic Nuzene96
>> Xiangsheng Factory Supply 50L Stainless Steel Milk Bucket Milk Can
>> Sample Customization Injection Mold Maker Large Rattan Design PP Garden Plastic Table Stool Chair Mould
>> Cayken Multifunctional Kcy-100/3wdo Magnetic Drill Machine
>> High Precision CNC Surface Grinder, Surface Grinding Machine M3060 Table (600*300)
>> N/a Winkko Color Box Lithium Battery 40V Brushless Motor with CE
>> Engine Spare Parts for Kubota V1505 Cylinder Head 16060-03042
>> Sea World Playground Inflatable Jumping Castle with Slide for Kids
>> Stearate paraffin wax granulation machine depilatory wax pelletizing machine
>> High Quality Health Sweet and Natural Dried Pineapple Fruit Food
>> Manufacturer of High-Efficiency Double-Station Power Battery Module Laser Welding Machine
>> 22961434A Auto Chassis Parts Front Strut Cover fit Chevrolet EG5 - Malibu XL 2019-2022
>> Custom Logo High Precision Constant Velocity Joint for OEM & ODM
>> Wholesale Decoration Charming Floral Fresh Flower Eustoma with High Quality
>> Yonthin Good Quality Automatic 15 Needles Hat Logo 8 Heads Embroidery Machine Computerized for T Shirt
>> Genuine Iron Fenders For 2010-2017 BMW 5 Series F10 F18 Facelift 2021 G30 G38 M5 With LED Light Fender
>> Sanitary Steam Full Automatic Flash Uht Tubular Sterilizer for PLC